...ows.
from the earth terminal on the jack, run a wire to the ground which is normally on the top of the Volume pot. Then from the positive (Or live) side of the jack run a wire to the Middle termina...
...tt and Jim, I'd add one thing about setting up your pickups. Start by getting them even in terms of volume.
I start with the bridge pickup. I set it for height first, trying to get the best ...
... did some research for you and it looks as though there are about three reasonable options.
1. Using a volume pedal and delay.
2.A fernandez sustainer?
3.A sustainer pick-up.
Demo of N...
... can use with the PSM-5. As it is, I plug my guitar into a wah, an over drive pedal, a delay pedal and a volume pedal. In my effects loop are the lesser used pedals like phaser, compressor, flanger,...
I bet he sets his gain and tone BEFORE he cranks the volume up!
were I got it) Carvin also dose this, I use one volume,one tone and a toggle to kick in bridge pickup.
...ng feedback on my tube amp? Its a Taynor YCV40WR and this happens when I am on the gain channel, with the volume about 3,4, even when I am not playing....
...er Tremulator), even with the mods and shipping costs.
All mods I've come across deal mainly with volume loss of a stock TR-2.
Analog Man offers a $45 mod (http://www.analogman.com/boss.htm#t...
I did the basic Little Gem, and yes, it is loud enough to accompany unmiked vocals. I suspect that the volume is directly related to the speaker and cab though, so your mileage may vary.
...e an electrical problem. I've had it for less than two weeks and all of a sudden unless both pickup volume dials are at max, there's a loud hum. Same deal when either of the two is turned ...
... like using my nano clone chorus, but find it hard to turn on and of while playing as it cuts a lot of my volume.
Does anyone have any tips for me?
Thanks...
Hi
Is it ok for a stat to be wired to just volume pot with out tone control Pots?
I am having troubles on mh LP special - when I lower the volume - the treble dies.
What can I do to avoid this?
There is no comparison. You need to play them for yourself. Try a JMP 2204 Master Volume or an early JCM 800
2204 and all questions will be answered.
Hi
I have recently put new pickups on my Les Paul, and now the bridge volume and tone pots seem to be live and ungrounded.
does anyone have a fix for that?
...ver, this sounds like a classic tube problem:
Here is a little thing you can do: turn your gain/preamp volume way up, and slowly turn your master/poweramp volume down. If the noise stops when maste...
..., vibrato, 22 watts with one 12" speaker. One advantage of a re-issue model would be having a MASTER volume. fingers...
Hi Guest, welcome to our forum. There are a few things to check out ref your volume problem...You have done one of the things by trying a different guitar, you have now illiminated it being an amp pr...
...e clean channel. They can be useful for amps with only one channel and with tube amps that have no master volume control...
You might also want to check out the smicz TAD, which would give a noticeable cut in volume when it distorts: http://www.smicz-amplification.com/tad.html
...mods to it. It was hell getting the tone control back in... I'm still going to disconnect the treble volume control and make the other vol a master......
... more middle, the more you'll be heard in the mix. [I run my JCM800 this way too.] Set the gain and volume to taste. More gain equals dirtier sound, less gain equals cleaner sound. I preferred...
...ne if you stand out in the mix or not...just a small boost in the mid to upper mid..its not necessarly a volume issue either...
...ks for all the helpful info! okay, i`m looking at the basic effectron I model first. does that have a volume drop when engaged? and since there`s no power switch on the front (is there one on the...
... home. I was thinking that a 5 watt amp should do, but I am not sure if I need to get one with one or two volume controls.
Suggestions?...
... attention to when shopping for an amp for an acoustic guitar? I want to use it mainly for increasing the volume of tapping. My acoustic has a pickup....
...
are all Boss.
Chorus CH-1
Flanger BF-3
Digital Delay DD-6
Metal Zone - MT-2
TU-2 Tuner
Ernie Ball Volume Pedal
Which effects should I run through the FX loop, and which should I run direct ...
...gigged with it last night and it sounded great.
No longer directional.
I think I may have lost a little volume but not much.
The biggest changes in sound were that it cut the mids considerably.
Bu...
...a helpful muso who no longer needed them. All fine now except that the 2nd string sound is very low/dull (volume) compared to the other three that ring just fine. What could be up here?...
...e split the stereo signal from an effects pedal, and used BOTH of them live, in order to get the adequate volume.
One amp is a 25 year old Marshall Lead 12, and the other is a small Fender Sidekick...
The Content on this site is provided for general information purposes only. Your use of the Content, or any part thereof, is made solely at Your own risk and responsibility. By entering this site you declare you read and agreed to its
Terms, Rules & Privacy.
Copyright © 2006 - 2010 Axe Central